The CB1100 Community Forum

Not according to everybody on here ? Fitted the Triumph ones. THEY LOOK LIKE CRAP,
still they'll do the job until I find something else.

(06-13-2022, 04:29 PM)hondadownunder_imp Wrote: [ -> ]Not according to everybody on here ? Fitted the Triumph ones. THEY LOOK LIKE CRAP,
still they'll do the job until I find something else.

What looks bad about the Triumph ones?

Samurider carries them also. Not sure who makes them, but they sell them as part of their K10 kit or separately. I'm assuming that they look good in real life, though I've not seen them in person.

Kawasaki P/N 49006-1335 looks good, works and lasts on the '13 & '14 Honda CB1100.

I found the product was very durable years in direct sunshine every day in the hot summers. I detected no cracking and I did not treat the gaiters with any chemical products.

Installed the Kawasaki fork boots on both ‘14 STD and DLX. Great fit and a quality part.



Sent from my iPad using Tapatalk

(06-13-2022, 09:50 PM)mtneers_imp Wrote: [ -> ]Installed the Kawasaki fork boots on both ‘14 STD and DLX. Great fit and a quality part.



Sent from my iPad using Tapatalk

Roger that ...

Honda fork boots are available. Check post 17 and 18 of this thread:
[url=http://cb1100forum.com/forum/showthread.php?tid=14211&page=2]http://cb1100forum.com/forum/showthread....211&page=2

They are available through Mr. T. I think they were about $55 each if I remember correctly. They were used on the RS and 2019EX models that were not imported to the U.S., which is why going through Mr. T is necessary. I did a quick search for the boots and clamps listed since so much time had passed since the posts were written, but no luck finding them in the U.S..