The CB1100 Community Forum

Ziggy, Here is a link to the fiche for the exhaust. Shows all the parts. http://www.hondapartshouse.com/oemparts/...st-muffler

A '13 centerstand works fine on a '14 when installing the Yosh.

Yosh titanium hand-bent
http://i1030.photobucket.com/albums/y370...5bieug.jpg

Nice

(04-20-2017, 12:47 PM)Ziggy_imp Wrote: [ -> ]My '13 CB1100 had the RSCV full exhaust installed when I bought it last month. It has a great sound, it's not overly loud by any means, it looks great, and it attracts positive comments.

The only problem it is that my jacket smells like exhaust when I get off the bike. The plugs are clean, and there's no visible smoke. Best I can tell it's due to a) the lack of a catalytic converter, and b) the shortness of the exhaust and the fact that it angles up.

As much as I hate to do it, I'm probably going to pull the RCSV and replace it with a stock header (assuming that's where the cat is) and an RC3 slip-on. I can't be showing up at work smelling like a motor :-).

Thanks for this tidbit, I appreciate it a lot. Was looking at installing this exhaust, but also cannot show up to work smelling like a motor.

(08-07-2014, 06:37 AM)CIP57_imp Wrote: [ -> ]

(08-07-2014, 02:31 AM)shdwghst457_imp Wrote: [ -> ]It is compatible with the center stand, right?

Yes, just need to install the stop

Yes, just need to install the stop
I'm getting some chain rub on my center stand, does the stop prevent this from happening?

I went to my Honda dealer last week and they weren't aware of a stop/spacer for this. Do you have a link to the part(s) by chance?

Thanks

Do you know if Yoshimura RSCV compatible with CB1100RS '18? And where can I get it?

They're compatible with the newer CB1100rs.. If you can find one.

I tried finding a Yoshi pipe . Even went to the Yoshimura factory in Chino. No luck.. Webike? A 4 month wait. If they can get it. Then looked for a Morikawi.. 2 month wait..

Here is the ubsurd part: You pay over $1100 and you still get a mild steel pipe that is painted with high temp paint.
I went and bought a Mizuno from Webike. It was on my door step in 9 days from Japan. $450 including shipping. Mild steel and high temp paint. I brought it to a shop and had it ceramic coated for $300. A short race pipe for $700. Ceramic coated. Plus a removable baffle unlike the Yoshi or Morikawi. Very cool pipe. Different bend than the Yoshi to give it a gurgle sound which sounds pretty cool.
These are also compatible. Plus you can keep your centerstand.

Thanks @Rox, looking great! Do you have a full name of your Mizuno exhoust? model/links?

Does anyone know where I can get a black Yoshimura RSCV or Moriwaki full exhaust? If not, anyone want to sell theirs?