The CB1100 Community Forum

Throw a set of these in- nice easy power / tq gains for little work- little cost-

https://www.youtube.com/watch?v=M2iCySQ_P8s

Interesting trivia- that bike bascically uses the same throttle bodies our CB1100 does (32mm).

The TB themselves are the same casting- the spacing and linkage between them is different.

On that bike the stock velocity stacks are the 32mm- on our bike our stacks choke down to 26mm!!

I'd get a set of the stacks in the video shown above- but our airbox shape is different.

If I knew how to 3d print- I'd make my own.

(07-12-2021, 12:51 AM)PowerDubs_imp Wrote: [ -> ]Throw a set of these in- nice easy power / tq gains for little work- little cost-

https://www.youtube.com/watch?v=M2iCySQ_P8s

Interesting trivia- that bike bascically uses the same throttle bodies our CB1100 does (32mm).

The TB themselves are the same casting- the spacing and linkage between them is different.

On that bike the stock velocity stacks are the 32mm- on our bike our stacks choke down to 26mm!!

I'd get a set of the stacks in the video shown above- but our airbox shape is different.

If I knew how to 3d print- I'd make my own.

Yeah probably not worth the effort for 3hp gain. This bike has plenty pep for me at this time. I firmly believe that it’s more cost effective to buy a bigger bike to get more power instead of modifying Honda engineers excellence. Once I’m bored with the power I’ll step to cb1000.

Just letting you know they exist.

For me- that is cheap and easy for 4% wheel gain across many thousands of RPM.

Different strokes for different folks.

My take- Anybody can buy a bike. That's boring. I prefer to make it my own.