Can someone please help me to identify this part - i found it on my truck bed floor by the rear wheel on the left hand side after carrying the bike 140 miles on very rough roads - the pin is 10mm long - have checked most of bike except under the side covers and injector covers.
John
(09-21-2017, 03:50 AM)WK57ABF_imp Wrote: [ -> ]Can someone please help me to identify this part - i found it on my truck bed floor by the rear wheel on the left hand side after carrying the bike 140 miles on very rough roads - the pin is 10mm long - have checked most of bike except under the side covers and injector covers.
John
I just looked all over my 2014 standard and don't see one.
Sent from my SM-T710 using Tapatalk
That's a hitch pin. Don't recall any on the CB, but I'll walk out to the garage and have a look around
Retsel - thank you for looking - going dark now so will remove all covers in the morning and have a good look in there - went a short ride this afternoon and nothing fell off - 2013 CB1100A.
Doesn't look familiar. Do you have a wheel chock in the back of your truck? Looks like it could have come off something like that.
Ferret - this is a very small pin 10mm long - yes it is similar to a hitch pin in shape - but hitch pins are about 3'' long.
LongRanger - i doubt that its coming off anything but the bike - very sad, i keep everything in rubbermaid boxes - generator/portable winch etc in the truck bed.
Did it come from the "stud" holding the foot peg ?
From the factory they have a split pin but that could have been replaced by a tiny hitch pin.
Ferret's right - looks like the clip that holds pin that holds the hitch in a receiver.
can you put something in the photo with it for scale?