(06-05-2018, 10:59 AM)The ferret_imp Wrote: [ -> ]Boy, those look good kenny.
Too bad they get fully covered by the license plate...
(06-05-2018, 11:12 AM)kennyw_imp Wrote: [ -> ] (06-05-2018, 10:59 AM)The ferret_imp Wrote: [ -> ]Boy, those look good kenny.
Too bad they get fully covered by the license plate...
Too bad they get fully covered by the license plate...
But we'll know how nice they look under the plate.
Can't wait to get mine.
I forgot that you were having these done. They look great. Any leftovers for the '17s?
No leftovers, I decided to only do a single run but I did send the dxf to metalmaven in case he wants to start offering them. I still need to confirm the design with the real parts once they arrive but the paper version fit correctly.
You could also order one direct from the guy that made these but it is a 3-4 week lead time if he is busy like he was with this run.
(06-06-2018, 04:55 AM)kennyw_imp Wrote: [ -> ]No leftovers, I decided to only do a single run but I did send the dxf to metalmaven in case he wants to start offering them. I still need to confirm the design with the real parts once they arrive but the paper version fit correctly.
You could also order one direct from the guy that made these but it is a 3-4 week lead time if he is busy like he was with this run.
Ok, thanks, I'll probably just use your '17 template to "fabricate" one--I did that for my '14 and it worked out pretty good.
PM me your email and I can send you a 1:1 scale pdf to print.
The plates arrived yesterday, tonight I will pack them up to ship out tomorrow.
Hardware required for 2017 bracket:
3X M6 x 35 Flat head cap screws
3X M6 flanged nut (reused from stock bracket)
3X M6 fender washer (reused from stock bracket)
2X 1/4 ID x 7/8 OD x 1/4 Thk spacer
Hardware required for 2013-14 bracket:
2X M6 x 35 Flat head cap screws
2X M6 flanged nut (reused from stock bracket)
2X M6 fender washer (reused from stock bracket)
Hardware to mount license plate and frame:
4X M6 x 16 screw
4X M6 washer
4X M6 acorn nuts