The CB1100 Community Forum

I just installed SW-Motech's on my bike. One of the bolts had some oxidation but not as bad as pictured. I made sure to use loctite on the nuts securing the frame Bolts in place.

Also, others have recommended wrapping up the lower portion of the frame prior to mounting the U-bolt clamp to prevent scuffing of the frame itself

They seem to blend fairly well for the post part

@E11even_Hunnit, I see you didn't install engine guards in time

(07-31-2020, 09:19 AM)mrded_imp Wrote: [ -> ]@E11even_Hunnit, I see you didn't install engine guards in time

Unfortunately that was done by the previous owner. I got the bike that way

I like your bike mate