Anyone have an issue with turn signal burning through fuses? I noticed over the weekend my turn signals weren't working. Bulbs are fine, fuse was blown. Replaced the fuse, took it for a ride, signals worked a few times then stopped again. Another blown fuse. I suspect a short somewhere.
2014 - 12k miles.
Thanks for any insight.
Have you done any modifications to the bike? Different turn signals, led lights, wiring for a phone or GPS or anything electrical?
Hey billyfindchapel - welcome to the Forum!
I would agree with your initial assessment: Sounds like a marginal short somewhere in the associated circuit.
(05-03-2021, 01:14 AM)The ferret_imp Wrote: [ -> ]Have you done any modifications to the bike? Different turn signals, led lights, wiring for a phone or GPS or anything electrical?
No modifications affecting wiring. Installed engine guard bars and a rack mounted on the rear behind the seat.
I know it's highly unlikely, but you didn't pinch a wire while you were installing the rack?
(05-03-2021, 05:57 PM)Cormanus_imp Wrote: [ -> ]I know it's highly unlikely, but you didn't pinch a wire while you were installing the rack?
Not a chance. I ride a lot, and the past couple weeks I've been riding 100 miles daily, 40 miles which is on some roads which cause a bit of a vibration due to how the road was laid. I'm gonna do some work on it this weekend and report back.