The CB1100 Community Forum

Here is a picture of the connector you need-- it is the 2 pin. http://cb1100forum.com/forum/showthread....#pid284387

If you need the 4 pin as shown on the page TxBikerGuy posted. It is this one: 4 pin HM 090 Male and Female locking connector. It is the second one down on the page.

If you want the 2 pin scroll down to the 2 pin--2 pin HM 090 Male and Female locking connector

They are Sumitomo connectors. I purchased the kit but only used 2 of them for my accessory connectors.

It will be the 2 pin HM 090 Milkmaster. Be sure to order a set to include the pins which you will have to solder on yourself.

They are actually crimped pins. I guess you could solder them if desired but they may not seat in the shell if the crimp ears aren’t bent over.

(06-22-2023, 08:48 AM)Lord Popgun_imp Wrote: [ -> ]They are actually crimped pins. I guess you could solder them if desired but they may not seat in the shell if the crimp ears aren’t bent over.

Yes, I crimped mine and ran a light solder over them "to be sure to be sure"!