MTC wrote: "...I may install my replacement set on my bike, but I'm still leaning toward biting the bullet on the OEM grips."
FWIW, I had the OEM heated grips installed by the dealership when I bought the bike right out of the crate. They have worked flawlessly, and they are unobtrusive in the looks department.
-fritz
(10-16-2018, 02:12 AM)tnelson99_imp Wrote: [ -> ]I like Oxford heated grips for a few reasons. They'll automatically shut off after a few minutes if you forget to turn them off, the controller has 5 different settings, and they're easy to install.
I used to run the kind where you put the element under your grips but after forgetting to shut them off a couple times and killing the battery I was done with that style. I also didn't like how hot the one grip would get and the other one would hardly feel warm.
https://www.revzilla.com/motorcycle/oxfo...ated-grips
The Oxford grips look good. Where/how did you mount the switch? Does it have a bracket?
Looks like the bracket is $4.95
Mine came with a simple metal bracket that I mounted to the clutch master with some double sided sticky tape. I'll try to remember to take a picture of it tonight.
I used Oxford heated grips on my ST 1300. I thought they were great. They came with a little metal bracket that mounted under one of the switch clamp bolts.
(10-16-2018, 02:46 PM)pekingduck_imp Wrote: [ -> ] (10-16-2018, 02:12 AM)tnelson99_imp Wrote: [ -> ]I like Oxford heated grips for a few reasons. They'll automatically shut off after a few minutes if you forget to turn them off, the controller has 5 different settings, and they're easy to install.
I used to run the kind where you put the element under your grips but after forgetting to shut them off a couple times and killing the battery I was done with that style. I also didn't like how hot the one grip would get and the other one would hardly feel warm.
https://www.revzilla.com/motorcycle/oxfo...ated-grips
The Oxford grips look good. Where/how did you mount the switch? Does it have a bracket?
The Oxford grips look good. Where/how did you mount the switch? Does it have a bracket? It isn't too difficult to install an inexpensive relay that only supplies power to the grip heaters when the ignition is turned on. I did this on my Guzzi 1200 Sport.