The CB1100 Community Forum

Many of you recommended this product to me. Decided to cut a vid of installation for those that may need the tutorial. Was really pretty simple. Thanks for the recommendation!

Well done Mike
I have those grip covers and haven't gotten around to fitting them - busy but mostly lazy

(07-02-2016, 04:13 AM)Rocky_imp Wrote: [ -> ]Well done Mike
I have those grip covers and haven't gotten around to fitting them - busy but mostly lazy

Haha. I know the feeling!!!


Sent from my iPad using Tapatalk

Nicely done MM.

Before I knew about GPs, I wrapped the grips in foam bicycle tape to get a bit more diameter.

This is an old thread, but I eventually got around to fitting the Grip Puppies to both of my Hondas and like them very much.

(02-29-2020, 06:08 AM)Rocky_imp Wrote: [ -> ]This is an old thread, but I eventually got around to fitting the Grip Puppies to both of my Hondas and like them very much.

They are indeed awesome, especially at soaking up any residual freeway engine buzz that might occur from time-to-time. No numb palm.

(02-29-2020, 07:21 AM)GoldOxide_imp Wrote: [ -> ]

(02-29-2020, 06:08 AM)Rocky_imp Wrote: [ -> ]This is an old thread, but I eventually got around to fitting the Grip Puppies to both of my Hondas and like them very much.

They are indeed awesome, especially at soaking up any residual freeway engine buzz that might occur from time-to-time. No numb palm.

They are indeed awesome, especially at soaking up any residual freeway engine buzz that might occur from time-to-time. No numb palm.
Just put grip puppies on and what a difference. Can't believe I didn't know about this sooner. I would say, it was a bit of a struggle getting them on. Not quite as easy as Memphis Mike made it look.

Grip puppies are definitely the way to go on the cb .

+1......