The CB1100 Community Forum

Let me know if you have questions.





Sent from my iPhone using Tapatalk

Hi

Could you look up the torque figure for the front engine bolts ( the long ones that go through the projections on the front of the crankcase, one each side ). I have a 2013 abs.

Many thanks

Lodger, the Front Engine Hanger Nut is 44 ft lbs, or 59 Nm or 6.0kgf m.

How did you get hold of loosenoodle's manual popgun?

The Forum secret decoder ring comes in handy sometimes...

(02-16-2019, 09:38 PM)Lord Popgun_imp Wrote: [ -> ]The Forum secret decoder ring comes in handy sometimes...

(02-16-2019, 04:26 PM)Cormanus_imp Wrote: [ -> ]How did you get hold of loosenoodle's manual popgun?

(02-16-2019, 09:38 PM)Lord Popgun_imp Wrote: [ -> ]The Forum secret decoder ring comes in handy sometimes...

(02-16-2019, 09:42 PM)Rocky_imp Wrote: [ -> ]

(02-16-2019, 09:38 PM)Lord Popgun_imp Wrote: [ -> ]The Forum secret decoder ring comes in handy sometimes...

Can a regular member like me and others get access to "these secrets" as well?
I confessed of all my sins last Saturday

There is only one ring and Guth awarded it to me And as it is documented on the board, I can prove it

I would post a picture of it, but mysteriously it will not show on film or digital media.

Too funny.

(02-17-2019, 01:20 AM)Lord Popgun_imp Wrote: [ -> ]There is only one ring and Guth awarded it to me And as it is documented on the board, I can prove it

I would post a picture of it, but mysteriously it will not show on film or digital media.

Try analog/bakelite case..

Well, it can be seen and documented that this case has reached the CEO.
Guth, can you certify that the Only Ring was given to Popgun only, please.
Needles to say, I have TWO, pure gold.