HP bags and mounts due to arrive tomorrow. Can't wait! Pics coming as soon as I can.
Woo hoo, should make for a nice looking setup
I didn't want to hijack the other thread...
Boxes have arrived!
Not much packaging, but not much needed I guess.
Bonus toys for the kiddies!!! Erwin Mainway plastic bags included!
FLASH! Ah-ahh.
Sexy back...
Innards...
Very nice. Can't wait to see them on the bike!
Sweet! Those look really nice. Have you done the turn signal relocation?[/u]
Man those are some serious hold down straps on the inside.
I didn't expect a thread hijack just a link between the two in case someone gets to the other thread they can get to this one easier.
Really looking forward to the install steps and photo guide...
Sent from my XT1055 using Tapatalk
I've got the blinkers off. Was about to attached the lower brackets. I'm not liking the metal to metal mounting of the two plates that sandwich the pillion rear set and how the instruction pics differ. Pics coming soon.
Should I be concerned???
To get the storage "cup" detached from bike. Remove the single screw and push this clip's center pin from under the bike.
Pick of the harness where the lights connect (lt blue = right, orange = left)
I'm going to continue with the bracket install despite my concerns. Hopefully, the German engineers that designed the system did the metal to metal mounting brackets for good reason.
Finished the install about midnight last night. Rode the bike for about 45 min today. With the bags empty, I don't even realize their on the bike until I glimpse them in the mirrors. My only complaint would be lack of any kind of extension for the turn signals.
